Check that the cables between the Interconnect PCA and the Main PCA are not damaged and are correctly connected.Check that the Front Panel cable is not damaged and is correctly connected to the Front Panel and to the Interconnect PCA.Description:Problem with communication between the Front Panel, the Formatter and the HDD. ![]() NOTE: Replace one part at a time and check if the error has cleared before replacing another. If the System Error continues, replace the Sausalito PCI PCA .Description:Main NVM failure - not detected, read/write failed or readback error.If the System Error continues, replace the Hard Disk Drive .If the System Error does NOT reappear, then the original slot could be faulty.If the System Error reappears, replace the Memory Module .Try installing the Memory Module in the other Memory slot and check if the System Error appears.Check that the Memory Module is installed correctly.Check that at least 256 megabytes of memory is installed in the Printer.If the System Error continues, replace the Main PCA .Description:CPU Fan is stopped or burnt.If the System Error continues, replace the Power Supply Unit .Perform the Electronics Modules Test () to troubleshoot the problem further.Description:Problem with the Power Supply Unit.Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and to the Sausalito PCI PCA.Check that the Trailing Cable is not damaged.Description:Problem with the Carriage PCA.If the System Error continues, replace the Ink Supply Tubes and Trailing Cable .If the printer cannot be upgraded using the normal process, upgrade using the. To solve errror upgrade with the latest firmware, at least 7.0.0.3. The humidity level will be displayed, a low level that would cause the error is around -20%. Click on the ePrinter Information Pagef and select the eCurrent Infomationf tab. ![]() You can check the humidity by using the EWS. ![]() Low humidity in the customerfs environment can be a cause of this system errror.Reconnect the power cord and power On the Printer. Switch the Power OFF from the back of the Printer and disconnect the Power cord.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |